He grew up in Watton-at-Stone, Hertfordshire and attended Richard Hale School, in Hertford. He has said that his earliest goal in life was to become an ice cream man. Grint was born on 24 August 1988 in Harlow, Essex, to Nigel Grint (born 1963), a dealer in racing memorabilia, and Joanne Grint (née Parsons born 1967).
#Harry potter 3d print files series#
Since 2019, he stars in the Apple TV+ psychological horror series Servant.Īside from acting, Grint supports several charitable causes. In 2014, he voiced the character of Josh in Postman Pat: The Movie, and from 2017 to 2018, he executive-produced and starred in the television series Snatch, based on the film of the same name. Grint made his stage debut in Jez Butterworth's Mojo in October 2013 at the Harold Pinter Theatre in London. In 2013, Grint's film CBGB was released and he was cast in CBS's new show Super Clyde. His first film project following the end of the Harry Potter series was the 2012 anti-war film, Into the White, in which he had a supporting role. Grint co-starred with Bill Nighy and Emily Blunt in Wild Target, a comedy. He has had starring roles in Driving Lessons, a dramedy released in 2006, and Cherrybomb, a drama film of limited release in 2010. From 2001 to 2011, he starred in all eight Harry Potter films.īeginning in 2002, Grint began to work outside of the Harry Potter franchise, playing a co-leading role in Thunderpants. Grint was cast as Ron at age eleven, having previously acted only in school plays and at his local theatre group. He rose to fame for his role as Ron Weasley, one of the three main characters in the Harry Potter film series.
Once the glue has cured, look at the piece make note of all the gaps you will have to fill.Rupert Alexander Lloyd Grint (born 24 August 1988) is an English actor. Line up the right half and press together, it's best to hold the pieces in the vertical position that it will be standing to get the pieces lined up.
Apply some crazy glue to the large section of the left half, and apply a bead to the vertebrae pieces. You should be ready to start some assembly. Lay a piece of sandpaper flat on a cutting mat and sand the flat surfaces to try and smooth out any warping or imperfections in the print. Go over the surface with some 100 grit sandpaper, lower grit if it's really rough, then work your way up. Also using the exacto knife, trim off imperfections from the surface of the print Using an exacto knife and pliers, trim the raft around all the edges of the print and pull off the support material (if used). When you have your print, first thing to do is cleanup. Note: All the Spinous Process (bone off the back of the vertebrae) should point downward But this instructable is meant to help you fix the final piece if these things have happened. Some were rougher than others, some warped off the print bed. And I'll go through the prints divided from bottom to top.Īside about print quality: When I had these pieces printed they had varying quality and fill %. I would suggest to have all the pieces printed at the same time, but that's up to you.
0 kommentar(er)
